NUX Sculpture Compressor
NUX Sculpture Compressor pedal offers a consistent volume output level and sharpens
the signals on top and bottom edges. When you start picking your guitar, it will
clean the loud (peak) notes and increase the sustain by raising the level of decaying
(quiet) notes. Sculpture also contributes to the signal foundation thats fed into the
rest of your effects chain.
It has 2 clip modes, simply you can switch between Clean Mode and Clip Mode by
holding the switch for 1 second.
The clean mode has a wide limit range from bottom to top so if your guitar slams
the limits too hard (like humbucker pickups) it is very suitable to control the
compression. You can also dial up a very soft and clean compressor for single
coil system guitars in Clean mode.
2 Compression Modes (Clean and Clip)
True Bypass / Buffer Bypass
Blend Circuit for adjusting transparency of compressor
-clip mode (clip light is on)If you want to squeeze your sound, Clip Mode
will make it tight like a cowgirl's jeans and the compressor will wrap all
over the signal. It is very suitable for the single coil guitars to compensate
the weak output.
When you adjust the knobs to catch a perfect balance between clipped frequencies
and a good sustain, blend circuit allows you to adjust dry/wet compressor effect
level on the processed signal. Whatever you dial-up on Sculpture Compressor, you
can simply adjust the opacity of the effected sound.
-True Bypass / Buffer Bypass
Sculpture Compressor has an embedded selectable buffer bypass.
You can change the bypass mode by turning on the power while holding the footswitch.